![]() Only the package name is required for installing packages from repositories. ![]() To install a specific version of a package, run: $ sudo yum install – Install Specific Version Of Package with yum in Linux The wd_rpm tag indicates that these versions are available from remote package repository. Here, it shows that there are two available versions of glibc-locale-source: version 2.28-151.el8 and version 2.28-164.el8_5.3. In this case, it shows that the glibc-locale-source package with version 2.28-151.el8 is installed indicates it was installed from wd_rpm package repository).Īvailable Packages: This section lists the available packages that can be installed from the configured repositories. Installed Packages: This section lists the packages that are currently installed on the system. Two packages are available to install from remote repository. Glibc-locale-source.x86_64 2.28-164.el8_5.3 wd_rpmįrom the output, we can see that there are 3 packages in total. Last metadata expiration check: 0:31:11 ago on Wed 02:01:41 AM GMT. You can use subscription-manager to register. This system is not registered to Red Hat Subscription Management. # yum list glibc-locale-source -showduplicates Run the following command to show all versions of a package, available in enabled repositories: In this post, we will show how to make yum list all available versions of a specified package and how to instruct it to install the particular one. However, there are situations where it may be necessary to install a particular version or revert to an earlier version of a package that is already installed. The default behavior of yum is to install the most recent version of a package from the enabled repositories. 5 ways to list installed packages in Linux.How to use yum to list All versions of Package in Linux.3 ways to Check RPM package dependency in Linux.4 ways to list files within a rpm package in Linux.If you did not understand the preceding paragraph then read the next section.This article is part of the following series. The bottom line is this: if you try to start an application program and it complains that it cannot connect to the database, you should consult your site administrator or, if that is you, the documentation to make sure that your environment is properly set up. The environment variable PGPORT might also have to be set. For example, if the database server machine is a remote machine, you will need to set the PGHOST environment variable to the name of the database server machine. If your site administrator has not set things up in the default way, you might have some more work to do. Be sure to follow closely the section about setting up the appropriate environment variables. If you are installing PostgreSQL yourself, then refer to Chapter 17 for instructions on installation, and return to this guide when the installation is complete. ![]() PostgreSQL can be installed by any unprivileged user no superuser ( root) access is required. Doing so is not hard and it can be a good exercise. If you are not sure whether PostgreSQL is already available or whether you can use it for your experimentation then you can install it yourself. If that is the case, you should obtain information from the operating system documentation or your system administrator about how to access PostgreSQL. It is possible that PostgreSQL is already installed at your site, either because it was included in your operating system distribution or because the system administrator already installed it. Before you can use PostgreSQL you need to install it, of course.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |